WPM®CRACK INDUCING WATERSTOP UNIVERSIAL

Waterproofing element for below-grade reinforced cast-in-place concrete structures that control and waterproofs concrete shrinkage cracks while maintaining the structure's strength properties

The WPM® CRACK INDUCING WATERSTOP UNIVERSIAL is used in below-grade cast-in-place concrete structures between the reinforcement steel in the wall and the floor slab to make a controlled and watertight binding keyway-shaped shrinkage crack. The element is installed between the reinforcement rebars at a calculated distance depending on the design.

• Controlled and waterproofed pre-defined shrinkage crack point
• Load-bearing watertight binding keyway-shaped shrinkage crack
• Special coating, highly elastic, not reactive with water
• The polymer coating turns homogeneous with concrete
• Watertight against pressurized water up to 24 m (2.4 bar), officially tested at TalTech University - N° 372-A/19
• Tested for water pressure up to 15 bar - test protocol no.1/2024
• Made in Estonia

• Steel material: galvanized steel
• Steel sheet width: 150 mm
• Steel sheet length: 2,2 m
• Steel sheet thickness: 0,7 mm
• Coating: polymer coating
• Thickness of the complete sheet: approx. 1,7 mm
• Color:
• • Polymer coating: dark grey
  • Galvanized steel sheet: silver
• Z-shaped galvanized steel sheet: foldable as 50, 60, 80, 100 mm
• Temperature resistance: -35°C - +75°C
• Working temperature: no limits

6 x 2,2 m details,  joint clips, fixing glue tubes